Capacitor caps
The figure shows an electrolytic capacitor, and the aluminum pole ear will be welded to the aluminum cover. Can weld one, two, three, or four pole ears.
Battery connector with copper diaphragm
Multiple layers of battery conductor foil made of copper were welded to the nickel-plated copper conductor and were used to ensure minimal conductivity loss.
IGBT module connection (insulated gate bipolar transistor)
As one of the power semiconductors, can be used in automotive electronics to tool machine, consumer electronics and other uses. A ultrasonic process was used to ensure optimal electronic conductive connection.
Carbon brush copper connection
Because of the ultrasonic wave process, no additives are required. The resulting material-to-material binding is characterized by a minimum contact resistance.
Copper tubes with refrigerant looping inside
After the cold circuit copper pipe is filled through the filling valve, the pipe is cut through the ultrasonic welding machine, and the air-tight welding is performed to seal the cooling loop. This application can also be used for aluminum tubes.
Soft pack battery
Battery positive and negative electrode multi-layer foil connection, ultrasonic welding process can reduce the output loss, control the heating in the minimum, effectively improve the performance of the battery.
Power bank
With the frequent use of mobile phones in today's society, to meet the needs of electricity available at any time, action power supply has become a ubiquitous commodity. Using ultrasonic welding technology, the upper and lower shells melt each other.
Battery parts welding
To complete the ring welding through ultrasonic torque welding technology, only a small amount of high heat energy is gently imported into the weld area to ensure the stable conduction of the battery components.
Semiconductor heat dissipation module
Uses ultrasonic welding to economically and efficiently secure copper sheets to electronic components without causing damage.
Solar panel
Through the vibration friction of ultrasonic, the surface temperature of adjacent materials is increased, and finally the welding effect is achieved. It can achieve efficient and accurate welding, while avoiding the damage of thermal stress to solar energy.
Transformer
Ultrasonic welding technology can deliver energy directly to the connection area.
Inductance coil
Connect the pin of the stator to the enameled winding wire in ultrasonic mode.
Electric vehicle motor
With the sales volume of electric vehicles increasing year after year, the supply of motors is under considerable pressure to improve the operation efficiency of the production line. Through the ultrasonic welding, will not cause damage to the object surface, there will be no high temperature impact.
Battery Voltage Tap
The cables are soldered to the terminals as branch nodes for optimum conductivity.
Toroidal inductor
Magnetic ring inductor is widely used in electronic circuits and can be used to filter high frequency signals to achieve the purpose of filtering.
Inductor
The application of bare copper wire and inductor pin welding is quite common. The ultrasonic wave process has stable welding, do not have to worry about the destruction of the inductor content, to ensure that the connection is complete and no burn.
Soldering copper cables to terminals
Ultrasonic welding is suitable for various types of non-ferrous metals, can be firmly connected to high-voltage cables, the process of the parts under the thermal stress is much smaller, while shortening the cooling time.
Terminals
This involves the power and automotive industry, often used in welding batteries and cable and terminal connection, precision and firm welding is a very important link.